Optoma HD600X Guía de usuario descargar pdf (Pagina 44)

4444

Appendices

Lamp Replacement Procedure:

1. Switch off the power to the projector by pressing the “POWER” button.

2. Allow the projector to cool down for at least 30 minutes.

3. Disconnect the power cord.

4. Unscrew the two screws on the cover.

5. Lift up and remove the cover.

6. Unscrew the two screws on the lamp module.

7. Lift up the lamp handle and remove the lamp module slowly and carefully.

To replace the lamp module, reverse the previous steps.

8. Turn on the projector and use “Lamp Reset” after the lamp module is

replaced.

Lamp Reset: (i) Press “MENU”  (ii) Select “OPTIONS”  (iii) Select

“Lamp Settings”



(iv) Select “Lamp Reset”



(v) Select “Yes”.

The screws on the

lamp cover and the

lamp cannot be

removed.

The projector

cannot be turned

on if the lamp

cover has not been

placed back on the

projector.

Do not touch the

glass area of the

lamp. Hand oil can

cause the lamp to

shatter. Use a dry

cloth to clean the

lamp module if it

was accidentally

touched.

Note

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 50 51 52

Sin comentarios

Optoma HD600X Guía de usuario Pagina 44